Description
Overview
A Canon-style charge connector in 3-pin form, as a male plug, a female socket, or the mated pair. Two conductors leave on a 2-wire interface cable, so it is a cable-end part, not a board connector.
Specifications
- Contacts: 3 pins
- Conductors: 2-wire cable
- Genders: male plug, female socket, or both
- Body: Canon-type small-EV charge connector
- Termination: cable leads
Purpose
E-bikes, balance cars and bikes use their own charge-port body, so a cracked inlet cannot take a generic barrel jack. This restores the plug-to-socket interface without rewiring the charger.
Applications
- E-bike charge port replacement
- Balance car and hoverboard leads
- Bike battery pack charge tails
- Scooter charger repair
How to Use
- Check which half the vehicle uses, then order that gender or the pair.
- Meter the charger leads and note polarity before cutting.
- Solder both conductors, insulating each joint separately.
- Mate the halves only one way and seat fully.
- Caution: keep the coupling dry; a corroded pin heats up while charging.
- Pull-test the cable and re-check continuity.










Need help specifying wire?
Review conductor size, insulation, voltage drop, winding requirements and inspection criteria.





























Reviews
There are no reviews yet.