Description
Overview
A small breakout board carrying a Type-C or Micro USB female socket and fanning its contacts out to solderable pads. It turns a fine-pitch phone connector into something a hand iron or a header can reach, and ships bare, with a PH2.0 header, or with a cable fitted.
Specifications
- Socket: USB Type-C female or Micro USB female
- Board: DIP breakout / soldering adapter PCB
- Variants: Type-C, Type-C with PH2.0, Type-C with cable, Micro, Micro with PH2.0, Micro with cable
- Termination: bare pads, PH2.0 header, or pre-attached cable
Purpose
Soldering to a phone socket shell is where DIY USB builds usually fail. This moves the fine contacts out to pads you can see, and the cabled versions skip soldering entirely.
Applications
- Powering breadboard and perfboard builds
- Charging port repair pigtails
- DIY power banks and battery packs
- Cable and charger test fixtures
How to Use
- Identify VBUS and GND pads before soldering anything.
- Tin the pads and wire ends separately, then join.
- Solder one conductor at a time and check for bridges under light.
- Caution: reversing VBUS and GND kills the board and whatever it feeds – buzz the polarity out first.
- Anchor the cable with a zip tie so the pads take no strain.








Need help selecting a power connector?
Review the XT/EC5 comparison, wire gauge and the complete OEM sourcing checklist before ordering.




























Reviews
There are no reviews yet.