Description
Overview
A USB 3.1 Type-C female socket with solderable wire tails and a rubber ring seal, built to sit in a device wall rather than on a PCB. It comes in 2, 4 and 6-pin versions, the 6-pin in two pinouts.
Specifications
- Interface: USB 3.1 Type-C, female socket
- Termination: wire tails, not board-mount
- Pin counts: 2, 4, 6 (6-pin in A and B layouts)
- Sealing: rubber gasket round the body
- Rated use: high-current fast charging
Purpose
Some shells need a Type-C inlet where no PCB sits behind the port. Flying leads and a gasket let it pass through a wall while the inside stays dry.
Applications
- Sealed speakers and lamps
- Scooter and e-bike charge ports
- Power bank and battery box panels
- Field repairs where a board port will not fit
- DIY ports in water-resistant cases
How to Use
- Confirm the pin count and whether a 6-pin port uses the A or B layout.
- Trial-fit the socket and its ring in the panel hole before soldering.
- Solder the leads short and insulate every joint.
- Seat the socket with the gasket evenly compressed.
- Caution: the current rating depends on the wire attached, so size the leads for the charge current and never swap supply and ground.













Need help selecting a power connector?
Review the XT/EC5 comparison, wire gauge and the complete OEM sourcing checklist before ordering.































Reviews
There are no reviews yet.