Description
Overview
A 30-piece pack of 2-pin LED strip connectors, each on an 18 cm cable ending in a USB connector, so 5050 strip can be powered without soldering. Two strip widths are offered, 8 mm and 10 mm, both for DC5V strip.
Specifications
- Pack quantity: 30 pieces
- Contacts: 2-pin
- Cable length: 18 cm
- Strip width: 8 mm or 10 mm
- Strip type: 5050, DC5V
- End connection: USB connector
- Attachment: clip-on, no soldering
Purpose
Cutting and re-powering 5V strip usually means soldering pads that bridge or lift easily. These clips press onto the strip instead, and the USB end plugs into a supply already to hand.
Applications
- Under-cabinet and shelf lighting
- PC case and monitor backlighting
- Runs fed from a USB power bank
- Craft, model and display lighting
- Short test lengths on the bench
How to Use
- Cut the strip cleanly between the marked cut points so both pads stay intact.
- Lift the clip, slide the strip in pads-down against the contacts, close it.
- Check it lights before fixing in place; if dark, reopen and flip the strip.
- Use the 8 mm or 10 mm variant that matches the strip.
- Power the USB end from 5V DC only, never 12V or mains, and keep the joint dry.





Need help selecting a power connector?
Review the XT/EC5 comparison, wire gauge and the complete OEM sourcing checklist before ordering.





























Reviews
There are no reviews yet.